Printronix T5204R Administrator's Manual page 86

Chapter 3
Main Menu
COAX
2, 3, 7
SETUP
(page 153)
Primary Sets
Translation Tbl
PA1
PA2
Buffer Reprint
Buffer Print
Coax Type
Active Char Set
Secondary Sets
Early Print Cmpl
SCS Buffer Cntrl
Alt. Set 80-9F
Intervention Req
CR At MPP + 1
NL At MPP + 1
Position Aft FF
Last Char = FF
Null Suppression
FF Validity
Auto Skip At End
FF After Job
CR, EM, & NL
Translate Table
Host Override
Format Control
Cancel IGP/DCU
Lead-in Chars
5
User-Defined St1
5
User-Defined St2
5
User-Defined Stp
Change Case
Set Text Orientn
Max. Print Width
NOTES:
Italicized items are available only when Admin User is set to Enable (in the PRINTER CONTROL menu).
1
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 127. If you
change the Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
2
Appears only if the CTHI option is installed.
3
Appears only if selected as the Port Type (under C/T PORT).
4
Appears only if the CTHI emulation (under PRINTER CONTROL) is set to Simp Prot Conv.
5
Appears only if the "User Defined" option in the "Lead-in Chars" menu is selected.
6
Does not appear if IPDS is installed.
7
Does not appear if CTHI emulation (under Printer Control) is set to Simp Prot Conv..
86
TWINAX
2, 3, 7
SETUP
(page 156)
Primary Sets SPC Type
6
Translation Tbl Logical Buf Size
Buffer Print Intervention Req
Twinax Type Buffer Print
Active Char Set Translation Tbl
PA1
Secondary Sets
5225 World Trade PA2
Cancel IGP/DCU Buffer Reprint
Lead-in Chars Null Handling
5
User-Defined St1 SPC Null Supp
5
SPC Space Supp
User-Defined St2
5
User-Defined Stp SFCC Char
User-Defined St1
Alt. Set 80-9F
Graphic Chek Err User-Defined St2
Graphic Chek Cod User-Defined Stp
LAC Option NL At MPP + 1
LAC Approx.
Set Text Orientn
Host Override
Format Control
Max. Print Width
SPC COAX
SPC TWINAX
2, 3, 4
SETUP
SETUP
(page 158)
(page 159)
SPC Type
SFCC Char
User-Defined St1
User-Defined St2
User-Defined Stp
SPC Char Set
Translation Tbl
Buffer Print
5
5
5
2, 3, 4
5
5
5