Printronix T5204R Administrator's Manual page 173

P-SERIES
SETUP
(from page 172)
Auto LF Define LF
Code
Disable* LF = CR + LF*
Enable LF = LF
Select EVFU
SFCC Select
1* Enable*
0 to 7F Disable
Text Host
Position Command
Bottom of Line* Enable*
Top of Line Ignore All
Ignore CPI
Ignore LPI
Form Form
2 3, 5
Length Width
4
24 or 36 lines* 04.1, 06.6, or 08.5 inches*
0 to 144 lines 00.0 13.6 inches
Notes:
* = Factory Default
1
When the CTHI option is installed, the factory default is Printable.
2
All three Form Length submenus work in conjunction. When you change the default in one submenu, the default
values in the other two submenus change automatically.
3
This menu does not display when the CT, TN5250, or TN3270 emulation is selected.
4
The factory default value depends on the width of the printer model.
5
All Form Width submenus work in conjunction. When you change the default in one submenu, the default values in
the other two submenus change automatically.
Control Control
Code 06 Code 08
8.0 LPI* Elongated*
10.3 LPI Backspace
6.0 LPI
Alt. SFCC d
Set 80-9F Command
Control Code* Even dot plot*
1
Printable Double high
Reset Cmd Form
2, 3
CFG Ld Length
Disable* 4 or 6 inches*
Power up config 00.0 to 24.0 inches
Current config
Factory config
Form
3, 5
Width
4
104.1, 168.0, or 215.9 mm*
00.0 345.4 mm
Bold Overstrike
Disable* Enable*
Enable Disable
PSeries Dbl FF valid at
High
Normal* Enable*
P3/4/6/9 Compat Disable
Form
2, 3
Length
4 4
101.6 or 152.4 mm*
00.0 to 609.6 mm
Form
5
Width
4
41, 66, or 85 characters*
0 to 272 characters
TOF
4
173