Printronix T5204R Administrator's Manual page 215

Right Margin
Set in characters. Character zero is defined as the far right edge of the page,
and column numbering increments from right to left.
The range is 0-369 characters, and the factory default is 0 characters.
Rot. Char Size
•
Adjusted (factory default). Rotated (clockwise/counterclockwise),
expanded characters have a different size than an unrotated character
with the same size parameters.
•
Not Adjusted. Rotated, expanded characters will be the same size as
unrotated characters with the same size parameters.
Scalable Size
This option determines whether scalable characters are sized based on
normal scaling or based on the size of block characters. If the option Block is
set, then the scalable character are made to be the same size as block
characters in the old IGP-X00 printers.
The options are Normal (factory default) and Block.
SCS Buffer Cntrl
This option functions like the Early Print Complete feature ("Early Print Cmpl
(Coax, TN3270)" on page 197) but is for SCS only.
•
Don't Wait (factory default). The printer does not wait until the buffer is
printed before sending the print complete back to the host.
•
Wait Until Done. The printer waits until the buffer has printed before
sending the print complete back to the host.
NOTE: If set to Wait Until Done, printer speed may be reduced.
Select Char
Instructs the IGP which decimal character (0-255) to ignore from the host.
The range is 0-255, and the factory default is 0.
Select CPI
This item selects the characters per inch (CPI) value.
The options are 10.0, 12.0, 13.3, 15.0, 17.1, and 20.0 CPI.
The factory default is 10.0 CPI.
Emulation Submenus
215