Printronix T5204R Administrator's Manual page 328

Chapter 6
Diagnostics for E0xx, Bad NVM, or ILL NVM Errors
Table 18. LCD Message Troubleshooting (continued)
Displayed Message
PWR SUPPLY HOT
RBN TAKEUP FULL
Remove Used Rbn
Remove Label
RESETTING
PLEASE WAIT
RESTORING
BOOT CODE
328
Can User
Explanation
Correct?
Yes Power supply is hot.
Yes The ribbon takeup
spool is full.
•
Yes A label was
detected at the
front of the printer
by the Label Taken
Sensor. This is the
normal reminder
message when
Peel-Off or Tear-
Off Media Handling
has been selected.
•
A label was
removed, but the
"Remove Label"
message
remained.
•
The incorrect
Media Handling
mode was
selected.
Yes Printer finished loading
the program into flash
memory and is
automatically resetting
itself.
Yes Normal download
initialization message.
Solution
1. Determine that the fan is
operating and that all air
vents are unobstructed.
2. Move the printer to a
cooler area.
3. If the problem persists,
contact your authorized
customer service
representative.
1. Empty the takeup spool.
2. If the takeup spool is not
full, try re-threading the
ribbon.
3. Disable Rbn Takeup Full in
the MEDIA CONTROL
menu.
1. Remove the label from the
front of the printer to allow
the next label to print.
2. Verify that a front door
assembly is installed on
the printer and that it is
properly closed. Ensure
that no debris is
obstructing the door mirror
or the Label Taken Sensor.
3. In the QUICK SETUP or
MEDIA CONTROL menu,
change Media Handling to
the correct selection.
No action required.
No action required.