Printronix T5204R Administrator's Manual page 317

Table 18. LCD Message Troubleshooting (continued)
Displayed Message
ERROR
OCCURRED
FLUSHING QUEUES
FAN FAULT
FILE EXISTS
Enable Overwrite
FILE SYS FULL
Add Flash
FILE SYS FULL
Delete Files
FILE SYS FULL
Optimize & Reboot
FILE SYS INVALID
Optimize&Reboot
FILE SYS WRITE
Check Flash
FILE UPLOADING
Please Wait
Can User
Explanation
Correct?
Yes An interim message
displays while the
printer discards host
data it cannot use
because a fault
condition exists. While
this message displays,
the asterisk (*) rotates.
No The printer detected
that the power supply
fan did not rotate.
Yes The printer operator
tried to save a file
using the name of an
existing stored file.
Yes/No Insufficient flash
memory available to
store file.
Yes Insufficient flash
memory available to
store file.
Yes Insufficient flash
memory available to
store file.
Yes/No File system not
detected or flash was
corrupted.
Yes/No Problem writing to flash
memory.
Yes File is uploading to
PNE.
Fault Messages
Solution
Wait. When the asterisk (*)
stops rotating, a different fault
message will appear;
troubleshoot the final
message. Contact your
authorized customer service
representative.
1. Verify that the fan rotates
when the printer is first
powered up and when the
printer moves media or
prints.
2. Call your authorized
service representative.
Enter the PRINTER
CONTROL menu and enable
the Overwrite Files feature to
overwrite the existing file.
For additional flash, contact
your authorized service
representative.
Enter the PRINTER
CONTROL menu. Use Delete
Files to delete unwanted files.
Enter the PRINTER
CONTROL menu and use the
Optimize & Reboot feature.
Enter the PRINTER
CONTROL menu and use the
Optimize & Reboot feature.
Power off the printer for 15
seconds, then power back on.
If the problem persists, contact
your authorized customer
service representative.
Wait for upload completion
before accessing printer front
panel.
317