Printronix T5204R Administrator's Manual page 197

Do FF at TOF
Determines whether the printer, with media already set at the TOF (Top-of-
Form) position, will advance media to the next TOF position upon receipt of
an FF command.
•
Enable (factory default). The printer will advance media from the present
TOF position to the next TOF position upon receipt of an FF command,
causing a blank form.
•
Disable. The printer will not advance media from the present TOF
position to the next TOF position upon receipt of an FF command.
Early Print Cmpl (Coax, TN3270)
Early Print Complete capability allows the printer to send print (order)
complete status to the host before the printer is actually done printing all data.
This option is valid only when the printer is in DSC/DSE mode.
•
Disable (factory default). The printer will suppress the Early Print
Complete response until all printing is complete.
•
Enable. The printer will send an acknowledgement to the host when it is
able to accept more data.
NOTE: When an Early Print Complete is enabled and an error occurs, there
may be data loss.
Early Print Comp (IPDS)
This parameter allows you to choose when to send a Print Complete to the
Controller.
•
Off (factory default). Print Complete is sent if the page is printed
completely.
•
On. Print Complete is sent immediately. The next page will be created.
This improves the print performance when starting the next page, but
degrades error recovery.
Elong./Alt. Font
Controls which host command sets elongated (double high) fonts and
extended character set.
•
ELNG=BS (hex 08) FONT=SO (hex 0E)
•
ELNG=SO
The factory default is Elng=BS Font=SO.
FONT=BS
Emulation Submenus
197