Printronix T5204R Administrator's Manual page 363

Command Sub-Command
CONFIG LOAD
SAVE
SETMENU
POWERUP
PRINT
DELETE
UPLOAD
DOWNLOAD
Table 32. General PTX_SETUP Commands
Parameter
Cfg
Cfg
Value;Menu_tag
Cfg
Cfg
Cfg
Port;Cfg
Cfg
General Commands
Description
Cfg can be 0-8. The PTX_SETUP
will load configuration Cfg. If
configuration Cfg was not previously
saved, the operator panel will
display an error message and the
current configuration will be kept.
Cfg must be 1-8. This command will
save the current configuration as
configuration Cfg. If Cfg is not in the
range of 1-8, the command is
ignored.
Menu_tag is the name of the menu
as defined in the menu file. Value is
the value to which the menu is to be
set.
Sets the power-up configuration to
Cfg and loads Configuration Cfg.
Cfg can be any value from 0-8,
where 0 is the factory default.
Print Configuration Cfg. Cfg can be
a number 1-8, or one of four pre-
defined configurations. The four
non-numeric configurations are
requested using the first character
for the CURRENT, FACTORY,
POWERUP, or ALL configuration(s).
Deletes Configuration number Cfg.
Cfg must be in the range of 1-8.
This command uploads the
configuration stored in location Cfg
to the port specified by Port. Port
must either be 1284 or SERIAL. Cfg
may be 1-8 or ALL.
This command saves the
configuration data that follows as
configuration Cfg. Cfg must be 1-8
or END.
363