Printronix T5204R Administrator's Manual page 146

Chapter 3
PRINTER CONTROL
Max Cache Memory
The Maximum Cache Memory option specifies the size of the memory block
that can be allocated to the font cache. The font cache stores bitmaps that are
created on demand from the font outlines stored on the printer flash. The
cache allows the printer to print scalable fonts at optimum speed.
To calculate the memory requirement, use this equation:
horizontal
resolution x
The allowable range is 50 KBytes through 2000 KBytes in 50-KByte
increments.
The factory default is 2000 KB.
Max Cached Char
The Maximum Cached Characters option specifies the size of the largest
character that can be stored in the font cache. To calculate the memory
requirement, use this equation:
horizontal resolution
x
For example, with a print head that prints at 203 dpi you would use the
following formula:
Therefore, select a value that is equal to or greater than 5,151. The closest
available value is 6 KBytes.
The allowable range is 1 KByte through 20 KBytes, in 1-KByte increments.
The factory default is 01 KBytes.
NOTE: For most applications, the default settings for font memory are
146
average
character
vertical height
resolution x (inches) x
vertical resolution
x
203 X 203 X 1 X 1
8
acceptable. Therefore, do not change the defaults unless your
application requires an uncommon memory configuration.
average
character # of characters
width to be cached
(inches) x
8
average
character height character width
(inches) x (inches)
8
= 5,151