Printronix T5204R Administrator's Manual page 138

Chapter 3
PRINTER CONTROL
LP+ Emulation
This item selects the line or dot matrix printer to be emulated by the printer.
•
P-Series (see page 172)
•
P-Series XQ (see page 174)
•
Serial Matrix (see page 176)
•
Proprinter XL (see page 178)
•
Epson FX (see page 180)
The factory default is P-Series.
CTHI Emulation
This item appears only when the CTHI option is installed.
CTHI Emulation selects the operation of the CTHI option as either a standard
or simple protocol converter.
•
Standard
With a standard coax interface, the printer emulates the following IBM
coax printer models:
•
•
With a standard twinax interface, the printer emulates the following IBM
twinax printer models:
•
•
The standard Coax/Twinax emulation selection will only be available if
Coax or Twinax is selected from the HOST INTERFACE menu.
NOTE: For more information, consult the Coax/Twinax Programmer's
•
Simp Prot Conv (Simple Protocol Converter)
The Simple Protocol Converter (SPC) option allows those who use add-
on coax or twinax protocol converters to produce the same output on a
Printronix thermal printer with the Coax/Twinax (CTHI) capability as done
using a non-CT printer with the third party converter interfaces. The SPC
gives the printer the operational ability to connect to any PC or network
system supporting parallel or serial interfaces, and to three different IBM
host systems.
•
•
•
138
3287 Models 1 and 2
4234 Model 1
4234 Model 2
5225 Models 1, 2, 3, and 4
Reference Manual.
System 3x
AS/400*
327x Control Units