Printronix T5204R Administrator's Manual page 221

Translation Tbl (TN5250, Twinax)
Prints a table of the twinax interface's current character set. This operation is
valid only when the twinax interface is the current interface.
True Vert 1/10
•
Disable (factory default). When disabled and in High Resolution, a
vertical line's length in one inch and 1/10 inch increments is interpreted as
70/72 inch and 7/72 inch respectively.
•
Enable. When enabled, a vertical line's length is interpreted exactly,
which is 72/72 inch in one inch increments.
Trunc Dyn Data
This submenu allows the user to truncate the dynamic data up to the
maximum data length specified in Create Mode.
•
Disable (factory default). If the dynamic data exceeds the maximum data
length, an error will report.
•
Enable. If the dynamic data exceeds the maximum data length, the data
truncates.
Truncate Alpha
•
Enable (factory default). Prevents the printing of Error 48 (Element Off
Page Error) if alphanumeric data, including spaces, extends beyond the
right side of the form.
•
Disable.
Twinax Type
This parameter defines the printer emulation as follows:
•
IPDS 256 Bytes (factory default)
•
IPDS 1024 Bytes
•
5225
•
4234
After the emulation has been changed, a POR status is sent to the host.
Typeface
•
Letter Gothic (factory default). Letter Gothic is a non-proportional font
where all of the characters take up the same amount of space when
printed.
•
Courier. Courier is a non-proportional (monospaced) font where all
characters take up the same amount of space when printed.
•
OCR-A / OCR-B. Optical character recognition fonts printing at 120 dpi
horizontally and 144 dpi vertically. Both fonts print only at 10 cpi.
Emulation Submenus
221