Printronix T5204R Administrator's Manual page 208

Chapter 3
EPSON FX SETUP
LAC Option
Allows the host system to load alternate character images into the printer.
This may be used for designing graphics, bar codes, and charts, or for printing
in foreign languages.
•
Enable (factory default). Prints the LAC character as defined.
•
Disable. Ignores the LAC definition from the host and prints from the
currently selected character set.
Last Char = FF
Determines the print line position when a Form Feed (FF) command is the last
code encountered in the print buffer.
•
On (factory default). Moves to the first print position on the second line of
the next form.
•
Off. Moves to the first print position on the first line of the next form.
NOTE: This option is ignored if Auto Skip At End is on.
If configured as a 3287, and a form feed occurs in the middle of a print buffer,
the printer defaults to the first print position on the second line of the next
form, regardless of the setting of this option.
Lead PDF Dist
Adjusts the leading and trailing character spacing distance of the PDF for
UPC/EAN barcodes.
The range is 0.01- 0.10 inches in 0.01 inch increments, and the factory default
is 0.10 inches.
Lead-in Chars
You can enable additional printer features which are not accessible through
standard coax emulations. To access these features, send text commands in
the data stream. The commands must have a start and end code. Three sets
(each containing a start and end code) are available:
•
User Defined (factory default)
•
Set 1
•
Set 2
•
Set 3
208
start code: <%
end code: >
start code:¬¬
end code: $
start code: _%
end code: _