Printronix T5204R Administrator's Manual page 370

Appendix G
The PTX_SETUP Commands
Command Sub-Command
ENGINE MEDIA_HANDLING
MIRROR
MODE
WIDTH
ODV
RFID OVERSTRIKE_REPORT
STATISTICS_REPORT
STATISTICS_CLEAR
PRINTJOB START
END
370
Table 33. Thermal PTX_SETUP Commands
Parameter
Value
Value
X
D
Value
1
ON/OFF
ON/OFF
jobID
jobID
Description
Sets the type of media handling:
0 - Continuous
1 - Tear-Off Strip
2 - Tear-Off
3 - Peel-Off
4 - Cut
Value of 0 turns mirroring off,
non-zero turns mirroring on.
Sets the print mode to Thermal
Transfer.
Sets the print mode to Direct
Thermal.
Sets the page width in 1/1000" units.
Enables the ODV unit so that ODV
begins verifying printed barcodes.
Enables/disables reporting of RFID
overstrikes to the host. The default
is OFF (disabled).
Enables/disables reporting of RFID
statistics to the host. The default is
OFF (disabled).
Clears the RFID statistics.
Start of job marker. Results in a
"start of job" message sent back to
host through the PPM port when a
job starts printing.
End of job marker. Results in a "end
of job" message sent back to host
through the PPM port when the job
finishes printing.