Printronix T5204R Administrator's Manual page 364

Appendix G
The PTX_SETUP Commands
Command Sub-Command
CONFIG OVERLAY
RESET
GET_NAMES
SET_NAME
CLEAR_NAMES
MPI_SELECT
PNE_PORT
364
Table 32. General PTX_SETUP Commands
Parameter
Cfg
"Port"
Cfg
MPI
Port
Description
This command overlays the
configuration data that follows on
existing configuration Cfg. Cfg must
be 1-8 (or END). If Cfg does not
exist then command is treated the
same as DOWNLOAD.
Reboots the printer.
This command uploads the names
of the configurations to the port
specified by Port. Port must either
be "1284" or "SERIAL".
This command downloads a name
for the configuration specified by
Cfg. Cfg must be 1-8.
This command resets all of the
configuration names to their default
values.
This command selects the active
Management Protocol Interface
(MPI). Currently there are two
selections "UCP" and "PXML".
This command selects the port that
the PNE will use to communicate to
the printer.
The valid ports are:
•
DISABLE
•
HOST_SERIAL
If Host I/O is set to Auto
Switching or Serial, the port
defaults to Debug Serial.
•
DEBUG_SERIAL
•
ETHERNET
•
USB
NOTE: If ETHERNET is selected
but not enabled, the
selection will revert to
DISABLE.