Printronix T5204R Administrator's Manual page 271

C:<Enter>
cd \download<Enter>
13. Start the FTP (file transfer protocol) program by typing:
ftp xxx.xxx.xxx.xxx<Enter>
where xxx.xxx.xxx.xxx is the IP Address of the printer.
14. Log in to the printer by typing:
root<Enter>
You are given a password prompt.
NOTE: The default is no password. If the FTP program requires a password,
15. At the password prompt, press <Enter>.
16. Once logged in, type the following sequence at the command prompt to
download the filename.prg file to the printer:
cd dest<Enter>
cd d1prn<Enter>
bin<Enter>
put filename.prg<Enter>
where filename.prg is the file name you noted in step 9.
IMPORTANT
Do not interrupt the downloading process once it has started.
Interrupting a download will leave the flash memory on the controller
PCBA and NIC incompletely loaded, and the printer may not boot up.
17. When the download is complete, exit the FTP program by typing:
quit<Enter>
18. When the new software has successfully downloaded into flash memory
and the printer has reset itself, set the printer power switch to O (Off).
19. Remove the CD from the host computer and store it with the printer.
20. If required, reconnect the data input cable(s) to the printer.
21. Set the printer power switch to | (On).
22. Using the configuration printout(s) you made in step 1 on page 270,
restore the printer configurations.
contact the system administrator.
271