Printronix T5204R Administrator's Manual page 365

Command Sub-Command
CONFIG PANEL
PNE_PORT_NUM
PXML_PORT_NUM
LP MODE n/a
Table 32. General PTX_SETUP Commands
Parameter
LOCK
UNLOCK
Port Number
Port Number
Protocol
General Commands
Description
This command locks the operator
out of the printer's configuration
menu.
This command unlocks the printer's
configuration menu and allows the
operator access to the menus. By
default, the menu is unlocked.
This command sets the Port
Number the PNE uses to
communicate to the printer if the
PNE Port was set to Ethernet. This
command causes the printer to
automatically reboot.
This command sets the Port
Number the PXML and UCP will use
to communicate to the printer if the
PXML Port is set to Ethernet. This
command causes the printer to
automatically reboot.
Protocol must be 0-4. This
command resets the software
protocol, and is selected as follows:
0 - P-Series
1 - P-Series XQ
2 - Serial Matrix
3 - Proprinter III XL
4 - Epson FX-1050
365