Release Notes - Ness D8xD Installer Manual

releAse notes

manual 890-017 rev 1.6 mar 2016
• Connection diagram caters for dual voltage models, 17VAC & 20VDC
manual 890-017 rev 1.5 nov 2015
• P97E Clear Panel Options also defaults radio devices.
• P94E No Memory warning zones. The option applies only to zones 1-8
(both D8x and D16x)
V8.4 sep 2015
manual 890-017 rev 1.4
• Changed operation of P117E 6E
• Wiring diagram caters for 15VDC and Dual input (17VAC/20VDC) boards.
• Added wiring diagrams for sensors, page 9
• Bug fix in V8.0 P198E, P199E had been shifted to to P197E, P198E
• Bug fix V8.3 Day of Week Saturday with Autotimers display on Navigator fixed.
V8 Feb 2015
new manual 890-017 rev 1.0
MAJOR VeRSION ReleASe
• New PCB layout
• Now with 8 AUX outputs (1-4 on relay board or 1-8 on output expander/s)
• Added modem chip, use any modem in 300baud mode
• Voice alarms and voice prompts using a preset voice message library
• Real time clock onboard
• Serial port different connector, now 4 pin
• Listen-in header changed
• Required power supply is now 15VDC for efficiency (Do not use 17VAC)
• Tamper/Prog link moved to corner of pcb
• Many new program options including
P117e 5e, used in combination with P117e 2e gives three sets of output
configurations for output expander/s.
P151e–P154e, 4e–8e AUX5–AUX8 output options
P155e–P158e AUX5-AUX8 Timers
P318e, P328e, P338e, 5e–8e Reader options for AUX-5-8
P117e 6e User Code 13-15 Toggle or Pulse
P160e Alarm Siren level
P161e Fire Siren level
P162e Chirp Siren level
P305e 3e DOTl Timer in Minutes
P305e 4e DOTl Timer in Hours
P354e–P389e Autotimer using AUX5–AUX8
P123e 1e Zone Alarms to Aux3
P124e 1e Zone Alarms to Aux4
P123e 4e Radio Key Panic Pulses AUX3
P124e 4e Radio Key Panic Pulses AUX4
P87e 5e Reduce tone output when dialling telephone number
P87e 6e Reduce tone output when sending alarm message
P87e 7e Reduce tone output when connecting to modem
P198e System Name
V7.8.6 oct 2014
Changes to manual only. Page 67, enable/disable user codes by AutoTime
applies to keypad codes only, not radio keys or prox fobs.
V7.8.5 mar 2014
Changes to manual only. Page 80, digit zero on remote phone tells panel
that commands follow.
V7.8.4 Feb 2014
Changes to manual only. Page 53, P96e Note: This option clears only the
20 event memory as read by KPX and lCD keypads. Ness Navigator touch
screen keypad's 80 event memory is not affected.
P54, improved description of User Code operation of outputs on expander 2.
V7.8.3 may 2013
Changes to manual only. Page 54, corrected reference to J5 connector - now
refers to AUX connector.
V7.8.2 Apr 2013
Changes to manual only. Added RCM mark. Internal clock timing warning
page 67.
V7.8.1 Jan 2013
Changes to manual only. Removed reference to RK3 radio key.
V7.8 April 2012
1. Allow * & # on serial ascii input.
2. Add version & model to status list
3. P68e 3e Radio 56bit, now defaulted ON
Added instructions for programming via NessPD
V7.7 January 2012
Fixed leap year issues.
V7.6 november 2011
NeSS D8X / D16X DelUXe CONTROl PANel – INSTAllATION MANUAl
Fixed Day Mode, triggering Aux2 did not timeout after 2sec but followed
zone state.
Fixed Real Time Clock speed up. Hardware change.
V7.5 september 2011
Fixed fire siren turnoff. It was changing to standard siren instead of switching
off.
Allow NAVIGATOR v2 keypads to display time stamped event memory. Up
to 80 events are displayed with TIMe, DATe and eVeNT. ZONe NAMeS
and USeR NAMeS are also displayed. The NAVIGATOR allows the user to
go back and forth through the event memory.
V7.4 April 2011
1. Added Program Option P69e 1e: Flash Strobe on Medical alert.
2. Fixed AUX2 turning off even though P121e 6e was selected.
V7.3 July 2010
1. Radio Processing. The time of an internal wait timer has been reduced
so that successive events are processed faster to prevent posible missed
messages.
2. Aux1 pulsing Aux3 and Aux2 pulsing Aux4 issue fixed. The NAVIGATOR
shows the AUX states, which has made the effect visible.
3. Ascii messages now include D8x output results. New messages are added
to indicate the states of the D8x outputs – including the AUX, Siren, Strobe,
Reset etc.
These new messages will allow the NAVIGATOR AUX 1 to 4 controls to also
control C-Bus outputs, when used with the new miniCentral C-Bus unit.
4. Watchdog Timer. The watchdog timer operation has been changed during
up/download via modem. An eeprom with slow programming times could
initiate the watchdog - stopping up/download from working
V7.2 may 2010
Allow leD keypads to operate correctly.
KeyPADS can be used in the following combinations:
• LED & KPX (or SATURN).
• KPX & NAVIgATOR.
• LED & NAVIgATOR keypads cannot be used on the same installation
V7.1 April 2010
1. extra keypad signal added to allow NAVIGATOR to show RSSI of pendants
and detectors in program modes.
2. Minor database number update allows older NeSSCOMS versions to
give 'a need to update' warning.
V7.0 April 2010
1. Added support for Ness Navigator Touch Screen keypads.
2. Added P126e 8e Disable one digit at a time display.
3. MeMORy DISPlAy OF PANIC, FIRe, MeDICAl.
When viewing memory the display of PANIC, MeDICAl, FIRe has been
changed to:
PANIC = exclude + Zone 1 ON
MeDICAl = exclude + Zone 2 ON
FIRe = exclude + Zone 3 ON
On a NAVIGATOR this enables these memory events to be distinguished.
4. low Battery detection improved.
5. Tamper Flash Rate. On v6.2 the tamper display flashes at a different rate
to help distinguish the tamper type. This changes to a single flash rate if a
NAVIGATOR touchscreen is connected.
6. ADSl Interference. Improved rejection of high frequency ADSl signals.
7. RTC. Stopped the resetting of RTC seconds on Prog Mode exit. This could
cause the RTC to be out by up to 1 minute every time Program mode exited.
v6.2 october 2009
Changed options
1. P64e 6e is now used for Strobe Flash on Home Arming by Radio.
2. AutoTimers 7 & 8 now allow Day Mode Auto-arming/disarming. Options
P383e 3e, P384e 3e, P388e 3e and P389e 3e changed to Brief Day Mode
arming/disarming. See pages 69, 85.
Defaults changed
P63e 3e Home Mode Sonalert, now defaulted ON.
P126e 1e KPX Keypad double key Panic, now defaulted ON.
P301e 2e Arm With Double Read, now defaulted ON.
operational Changes
93