Remote Operation By Telephone - Ness D8xD Installer Manual

V8.0 and later
This section applies to
TO CONNeCT TO THe PANel By
TelePHONe
MeTHOD 1. The connection is initiated
by the panel during an alarm message.
See page 83.
MeTHOD 2. The connection is initiated
by the user phoning the panel.
HOW TO INITIATe TelePHONe
ReMOTe CONTROl
1. Phone the panel telephone number
and listen for the required number
of rings (the normal double ring is
counted as one ring) and then hang
up.
2. Wait 10 seconds and then call the
number again within 50 seconds.
3. The panel will answer the second call
immediately and respond with an
audible tone similar to a fax tone.
4. Press the button on your
telephone to start the session.
5. listen to the voice prompts for
instructions.
6. When you're done, press
hang up.
telePHone remote Control
for V8.0 and later
Remote operation allows:
1. Control of Arming/Disarming, AUX 1 to AUX 8 and Zone excludes.
2. Voice updates on Arming state, Zone alarm and excluded state, warning states.
Prompts would be issued when one of these is changed.
OPeRATION
example:
When the user calls the panel using the accepted methods and after the panel stops
sending the answer tone sequence.
The user first presses key 3 and the panel starts the voice prompt:
This is your SeCURITy SySTeM.
To control the security system press STAR, then enter your USeR code, then press
HASH.
If the user does this correctly then the voice prompt continues:
To arm or disarm the system press 1. To control OUTPUTS press 2. To exclude
or include a zone press 3. To listen to reports press 4. To hang up press STAR then
PReSS HASH.
The user presses 1 to arm or disarm the system and the voice prompt continues:
To arm, Press 1. To disarm, Press 2. To return, Press STAR.
The user presses 1 to arm and the voice prompt continues with either of these
messages:
eITHeR
(assuming Area 1 was disarmed and that Area 2 is not remote armed)
Area 1 armed, Area 2 disarmed, To arm or disarm the security system press 1.
To control OUTPUTS press 2. To exclude or include a zone press 3. To listen to reports
press 4. To hang up press STAR then press HASH.
OR
(assuming Area 1 was already armed)
to
Invalid entry. To arm or disarm the security system press 1. To control OUTPUTS
press 2. To exclude or include a zone press 3. To listen to reports press 4. To hang up
press STAR then press HASH.
The user presses 2 to control outputs and the voice prompt continues with the
message:
Double press the selected auxiliary output 1 to 8. Then press STAR to activate or
HASH to turn off the selected output. Press STAR to return.
The user presses 33 STAR * and the voice prompt continues:
Auxiliary 3 ON
The user presses 33 HASH # and the voice prompt continues:
Auxiliary 3 OFF
The user presses 32 HASH (#) (Note that this is an incorrect sequence) and the voice
prompt continues:
To arm or disarm the security system press 1. To control OUTPUTS press 2. To
exclude or include a zone press 3. To listen to reports press 4. To hang up press STAR
then press HASH.
The user presses STAR then HASH (* then #) to hangup.
NeSS D8X / D16X DelUXe CONTROl PANel – INSTAllATION MANUAl
85