Connection Diagram - Ness D8xD Installer Manual

Telephone lead (Australia only).
Connect to Mode3 socket.
Main Board Rev8
D8x or D16x
LISTEN
Audio Alerts &
dialler listen-in
diagnostics.
Requires separate
audio amp & spkr
1. Listen Out 8 ohm spkr
2. not used pins 1 & 3
3. Common
4. +12V out
RECEIVER
Header for
connecting
optional Radio
Interface.
AUX1
AUX
AUX2
Aux outputs 1-4
AUX3
and connection for
AUX4
+12V
output expander/s
0V
SERIAL
J1 LINK
RS232 serial port
BOX TAMPER
READER
Power up with link off to enter
Connection for
installer program mode
up to 3 Ness
Weigand readers.
Also used for Ness PD
Portable Download tool.
BATTERY LEADS
(supplied)
BLACK
RED +
BATTERY CONNECTION
For 12V 7Ah Backup
battery (Ness BAT210)
Dual voltage power input.
to avoid damage please connect the
correct power supply as shown.
17VAC or
20VDC
Power InPut
non-PolArIty
yellow/Green
To panel earth (optional)
This power supply is included with most D8x/D16x
models (Australia only).
8
TAMP
TELEPHONE
+12V
ZoneS 9-16
D16x only
+12V
& PROGRAM LINK
= Sealed, normal state
= Tamper alarm state
RESET
SIREN
J1
17VAC or 20VDC
17V AC
POWeR SUPPly
Part No. 840-029
Non-Polarity
17VAC
NeSS D8X / D16X DelUXe CONTROl PANel – INSTAllATION MANUAl
CONNeCTION DIAGRAMS
N.O TAMPER SWITCH
(761-002) Colour: BLACK
Supplied with Ness siren covers
0V
12V DC output
Z8
Zone 8
C
Zone 7
Z7
Z6
Zone 6
C
Zone 5
Z5
Z4
Zone 4
C
Zone 3
Z3
Z2
Zone 2
C
Zone 1
Z1
12V DC output for detectors.
0V
Auto Reset fuse protected.
500mA max.
DAT
DAT (Blue) T
CLK
CLK (White)
COM (Black)
COM
+12V
(Red)
+12V
STR
BOX TAMPER SWITCH
(White) N.C. contacts
Connect to J1
17VAC or
20VDC
Power InPut
non-PolArIty
ALTERNATIVE TAMPER SWITCH WIRING
For N.C. Tamper Switches
N.C TAMPER SWITCH (SWI920) Colour: WHITE
END OF LINE RESISTORS
The default end of line resistor value is 2k2 (2200 Ohms). The EOL value is fully
programmable with a choice of 13 resistor values, see program option P129E.
Ness panels are supplied with 2k2 1% tolerance Metal Film resistors.
Colour code: Red, Red, Black, Brown, Brown.
ZONE WIRING
Zone
NORMALLY CLOSED
C
( N.C.) DEVICES
Zone
NORMALLY OPEN
( N.O.) DEVICES
C
from all 12V outputs.
navigator keypad* Saturn keypad
Up to 3 x 12V Screamer (100-238, 100-004)
Up to 2 x Strobe Light (NOI-300)
Up to 3 x Horn Speaker, 8 Ohm (NOI-110)
Polarity is not important for this output
*navigator keypad is compatible with D8x/D16x control
panels version 7.0 or later
20V DC
POWeR SUPPly
Part No. 840-054
20VDC*
* Optional power supply.
This power supply has positive and negative
20VDC output however the polarity is not
important in this case.
PCB V8
Detector
Detector
Maximum 3 mixed
keypads or 4 navigator
keypads per system.
KPX keypad