Configuring Windows For Mediaport 200 - Extron electronics mediaport 200 User Manual

3.
4.
5.

Configuring Windows for MediaPort 200

Use the following procedure to configure Windows 7 to enable use of the MediaPort 200
with a computer.
1.
Open the PCS configuration software and click the
figure 14, ).
1
Figure 14. Selecting the Audio Mode
In the panel of the
Audio Mode
radio button (
DSP with AEC
When you do this, the MediaPort disconnects from the computer and reboots, and PCS
closes.
Reopen PCS and reconnect to the MediaPort.
Connect a USB type A to B cable from the MediaPort 200 rear panel USB port to
a USB port of your computer running Windows 7. The appropriate drivers install
automatically. Figure 15 shows the message that is displayed above the Windows
taskbar during driver installation.
Figure 15. Driver Installation Message
When driver installation is complete, another message appears, informing you that the
drivers are installed and the device is ready to use.
General Settings
screen (
General Settings
). (By default, the
3 Standalone
MediaPort 200 • Installation
button (see
), select the
2
External
button is selected).
15