Extron electronics mediaport 200 User Manual page 62

Command
Auto Memories
Enable
Disable
View setting
Input (User Image) Presets
Values Saved in User Image Presets
User Image Presets
Contrast H Start H Image Position
Brightness V Start V Image Position
Recall preset
Save preset
Delete or clear preset
View preset availability
User Image Preset Name
Write name
Read name
NOTE:
Unnamed presets are shown as [unassigned]. To restore a default user image preset name, enter a single
X1$
space character for
X1)
NOTE: = Enable or disable Auto Memory: 0 = Off or disable, 1 = On or enable
X1$
= Preset name, up to 16 characters
X2^
= Input preset number: 1 – 16. Response is 3 digits padded with a zero.
ASCII Command
(Host to Unit)
E }
1 * 1 AMEM
E }
1 * 0 AMEM
E }
1 AMEM
X2^
2 * .
X2^
2 * ,
E X2^ }
X 2 * PRST
51#
E X2^ X1$ }
2 * , PNAM
E X2^ }
2 * PNAM
. These entries are valid only for previously saved presets.
Response
(Unit to Host)
]
Amem 1 * 1
]
Amem 1 * 0
X1) ]
With tagged responses
(verbose modes 2 and 3):
X1) ]
Amem 1 *
X2^ ]
2 Rpr
X2^ ]
2 Spr
X2^ ]
Prst X 2 *
]
16 characters
With tagged responses
(verbose modes 2 and 3):
]
PreI 16 characters
X2^ X1$]
Pnam 2 * ,
X1$ ]
With tagged responses
(verbose modes 2 and 3):
X2^ X1$ ]
Pnam 2 * ,
MediaPort 200 • Remote Configuration and Control
Additional Description
Set Auto Memory to On.
Settings are automatically
stored. Previous settings for the
incoming signal are recalled.
Set Auto Memory to Off. Manual
user image preset recall is
required to configure the input.
View current Auto Memory status
X1)
.
X2^
Recall user image preset .
X2^
Save user image preset .
X2^
Clear user image preset and
set its name to [unassigned].
Displays 1 or 0 for each user
image preset location.
1 = Location contains a preset.
0 = Location does not contain a
preset.
Set the name of user image
X2^ X1$
preset to .
X1$
View name of user image
X2^
preset .
56