Powering On; Default Cycle - Extron electronics mediaport 200 User Manual

B
C
D
E
F
G

Powering On

Apply power by connecting the provided IEC power cord to the MediaPort rear panel
power connector (see
source.

Default Cycle

When power is applied, the LCD screen lights and remains blank for approximately
30 seconds, after which Extron MediaPort 200 is displayed. After approximately
70 seconds, the unit part number and firmware version are displayed briefly (approximately
2 seconds). After these initial screens, the default cycle begins, in which the LCD screen
rotates every 2 seconds through four screens: the input video signal type and rate, the USB
video output rate, the USB audio input status and the USB output signal status. The default
cycle continues while the menu system is not in use.
The
power-up and during the default cycle.
USB LEDs — These four green LEDs light to indicate the connection and signal status
of the rear panel USB port.
Host — The rear panel USB port is connected to and enumerated with the host
•
computer.
Video Send — A video signal is being output to the host via USB.
•
Audio Send — An audio signal is being output to the host via USB.
•
Audio Return — Audio input is being received from the host via USB.
•
LCD screen — This LCD window displays menus, messages, and your selections
from menus and submenus (see
information).
Menu button — Press this button to access the MediaPort menu system and step
through the menus displayed on the LCD screen (
for details).
Adjust knobs — Rotate these horizontal ([) and vertical ({)
to scroll through submenu options and make adjustments to your selections.
Next Button — Press this button to step through the submenus displayed on the LCD
screen when a menu is selected.
USB Config port — Connect a computer to this USB mini B port for device
configuration and firmware upgrades.
figure 3,
flow diagram
on the next page shows the order in which the screens appear at
Menus on the LCD Screen
) (see
C
, on page 7). Connect the scaling bridge to an AC power
A
MediaPort 200 • Operation
on page 26 for more
Menus on the LCD Screen
rotary encoders
Adjust
25