Connecting To The Usb Config Port - Extron electronics mediaport 200 User Manual

a.
Connect the transmit wire to the left pin of the connector, which plugs into the Tx
(transmit) port on the rear panel.
b. Connect the receive wire to the second pin, which plugs into the Rx (receive) port.
c. Connect the ground wire to the last pin, which plugs into the ground port, marked
with G.
2. Connect the 9-pin connector end of the RS-232 cable to the serial port of the
computer.
3. Plug the wired 3-pole captive screw connector into the first three slots (labeled Tx Rx G)
of the 5-pole RS-232/+12V captive screw connector on the MediaPort rear panel (see
figure
See SIS Commands
commands to this port.

Connecting to the USB Config Port

The USB mini B Config port is located on the MediaPort front panel. It can be used to
configure the MediaPort via SIS commands and the PCS configuration software.
1. Use a USB A to mini-B cable to connect the MediaPort USB Config port to a USB port
on the computer.
CONFIG
Figure 10.
2. If this is the first time you have connected a MediaPort to this particular USB port on
your computer, one of the following screens may open.
NOTE: Installing the PCS software also installs the required Extron USB driver.
3, , on page 7).
K
on page 46 for information on sending configuration and control
USB Mini B
USB Cable
MediaPort 200 Front Panel MediaPort 200 Front Panel
HDMI USB
SIGNAL IN HOST
HDCP IN VIDEO SEND
LOOP OUT AUDIO SEND
LOOP HDCP AUDIO RETURN
Connecting to the Front Panel USB Config Port
USB A
USB
Ports
MedioPort 200
MENU
ADJUS S T ADJUST US
NEXT
MediaPort 200 • Installation
USB 1
Computer
12