Extron electronics mediaport 200 User Manual page 47

5. To enter or change information on any address screen:
Rotate the horizontal
•
setting.
Rotate the vertical
•
6. When finished editing the settings for the selected item, either press
editing screen for the next item, or press
menu (
Quick Setup
Figure 39 shows an overview of the
Advanced
Configuration
Menu
View Comm
Settings
Press
Next
Next
hold for 5 seconds.
Rotate either
Edit Comm
knob to select a setting.
Settings
Next
Serial Port
9600 8 N 1
Next
View the RS-232 port
parameters (view only).
Subnet Mask
255.255.0.0
Set the unit IP address.
Select an Octet Increase or decrease
selected number
• Range: 000 - 255
(each octet)
• Default: 255.255.0.0
Figure 39. Edit Comm Settings Menu
The
Edit Comm Settings
Serial Port: (View only) Shows the current baud rate, data bits, parity bits, and stop
•
bits settings of the unit.
• MAC Address: (View only) Shows the Media Access Code (MAC) address of the unit.
This address cannot be changed.
• DHCP Mode: Set DHCP to
addresses and obtains its IP address from a DHCP server. Ensure that DHCP is set to
before attempting to change any network addresses.
Off
knob ( [ ) to move the focus (blinking) to the desired
Adjust
knob ( { ) to increment or decrement the setting.
Adjust
Menu
).
Edit Comm Settings
and
Adjust
MAC Address
Next
0005A60989CD
Gateway Address
Next
0.0.0.0
Set the unit IP address.
Select an Octet
Increase or decrease
selected number
Range: 000 - 255
•
(each octet)
• Default: 0.0.0.0
menu contains the following items:
or Off. When DHCP is on, it ignores any entered IP
On
Next
to exit edit mode and display the next
menu.
DHCP Mode
Next
Off
Set the DHCP mode.
• Off (Default)
• On
IP Address
Next
192.168.254.254
Set the unit IP address.
Select an Octet Increase or decrease
selected number
•
•
MediaPort 200 • Operation
to display the
Next
Range: 000 - 255
(each octet)
Default: 192.168.254.254
41