Extron electronics mediaport 200 User Manual page 49

• SIS commands — Five types of reset are available via SIS commands:
•
•
•
•
•
See the
Mode Activation
1 Hold in the rear panel
button while applying power to the
MediaLink 200.
4 Hold in the
Reset
Reset LED blinks twice (once after
approximately 3 seconds and
again after 6 seconds). Then, within
1 second, press
Reset
(for less than 1 second).
5 Hold in the
Reset
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds). Then, within 1 second,
press momentarily (for less than
Reset
1 second).
NOTE: Mode 5 reset clears most adjustments. To save these settings, use the PCS control program
and select
Backup
program help file for more information).
Erase all user EDID files from flash memory.
Reset all device settings to factory defaults except IP and user files (items that are
reset are device-dependent).
Perform absolute reset but retain IP settings.
Reset all device settings to factory defaults but retain current firmware version.
Reset only IP settings to factory defaults.
Reset commands
Reset Modes Summary
Result
• Restores the factory-installed default
Reset
firmware version.
• Retains all user files and settings,
including drivers, audio adjustments,
and IP settings.
button until the • Sets the IP address, subnet mask,
and gateway address to the factory
defaults.
• Sets port mapping to the factory
momentarily
default.
• Sets DHCP to Off.
The Reset LED blinks four times in quick
succession during the reset.
button until the Performs a complete reset to factory
defaults except the firmware.
• Does everything that mode 4 does.
Resets all user-modifiable
•
configuration to default values,
including IP settings and real-time
adjustments.
• Deletes all user-loaded files, including
user web pages and images.
The Reset LED blinks four times in quick
succession during the reset.
from the
MediaPort 200
on page 61 for command descriptions and wording.
tab menu before you perform this reset (see the control
MediaPort 200 • Operation
Purpose
Use mode 1 to
remove a version
of firmware if
incompatibility
issues arise.
Mode 4 enables
you to set all IP
information to
factory defaults.
It does not replace
any user-installed
firmware.
Mode 5 is useful
if you want to
start over with
the default
configuration.
This is equivalent to
the SIS command
.
ZQQQ
43