Table of Contents
Advertisement
Available Input Video Signal Types
The
Input #N
Each input supports different video signal types as shown in the table below.
Video Input 1
*
YUVp/HDTV
YUVi
S-Video
Composite
NOTE: * = Default video signal type
Selecting and Configuring an Input
Depending on the video signal type of the selected input, different adjustments are available
for the different inputs. The table below details which submenu adjustments are available for
each video signal type.
Input
Adjustment
Film Detect
H Start
V Start
Total Pixels
Phase
H Active Pixels
V Active Lines
EDID
Use the following procedure to configure any of the three video inputs.
1.
Select an input from the front panel of the SME 100 (see item
Features" section on page 11.
2.
To configure the selected input, press the Menu button repeatedly until the
Input Config
3.
Press the Next button repeatedly until the desired submenu is shown on the LCD
display.
4.
Rotate either Adjust knob to configure the settings of the selected submenu
figure 17
(see
5.
After all adjustments have been completed, do one of the following to save the
configuration.
Press the Next button to display another submenu.
•
Press the Menu button repeatedly until the
•
appears, then press the Next button to return to the default display cycle (see the
"SME 100 Power Up
Do nothing more and wait until the LCD display returns to the default display cycle
•
(approximately 30 seconds).
submenu is used to select a video signal type for the currently selected input.
Video Input 2
*
RGB
YUVp/HDTV
RGBcvS
YUVi
S-Video
Composite
Auto Detect
YUVp /
RGB
RGBcvS
HDTV
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
primary configuration menu is shown on the LCD display.
on page 26 for information on using the Adjust knobs).
Procedure" section on page 18 to see the default display cycle).
Video Input 3
*
DVI
YUVi
S-Video Composite
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
b
in the
Exit Menu? Press NEXT
SME 100 • Front Panel Operation
DVI
X
X
X
X
X
X
X
"Front Panel
menu
30
Advertisement
Table of Contents
