Configuring Windows For Mediaport 200 - Extron electronics MediaPort 200 User Manual

Configuring Windows for MediaPort 200

ion
on
ATTENTION:
• In this guide, the following steps are performed with the MediaPort 200 in
Standalone audio mode and enumerated as
• If the MediaPort 200 is in External DSP with AEC audio mode, the steps are the
same. However, Windows will enumerate the MediaPort as
not
Speakerphone
1. Connect a USB type A to B cable from the MediaPort 200 rear panel Type B USB port
to a Type A USB port of the computer running Windows 7. The appropriate drivers
install automatically. Figure 22 below shows the message that is displayed above the
Windows taskbar during driver installation.
Figure 22. Driver Installation Message
When driver installation is complete, another message appears, showing that the drivers
are installed and the device is ready to use.
2. Right-click on the speaker icon (see figure 23
select
Playback Devices
displaying the
Playback
Figure 23. Speaker Icon and Menu on Windows Taskbar
NOTE: To access
Playback devices
1. Select
Start
2.
Select
Control Panel
3. Select
Sounds
Speakerphone.
, as shown in the following steps.
Speakerphone
below) on the Windows taskbar, and
1
( ) from the pop-up menu. The
2
control panel.
from the Windows Start menu:
Echo Cancelling
dialog box opens,
Sound
MediaPort 200 • Installation 27