Extron electronics mediaport 200 User Manual page 40

Aspect ratio — Lets you specify how much of the display the image will fill. Rotate
•
either knob to select
Adjust
aspect ratio of the input). The default is
In fill mode, if you want to set an aspect ratio adjustment for a single input rate,
•
you can select the correct size and position manually from the
menu ( and
Size Position screens
In follow mode, each input rate is displayed with its native aspect ratio (4:3, 5:4,
•
15:9, 16:9, 16:10) with the correct letterbox or pillar box settings, visible in the
and screens of the
Position
If you want a specific input or image raster to fill the screen in follow mode, you can
manually set the
Position
to match the current output rate
Size
NOTE: In follow mode, the MediaPort calculates the aspect ratio at the point
the signal is applied. If the image size or position is changed via the
menu, the aspect ratio of the image may no longer match the native
Control
aspect ratio of the input signal. To resize and re-center the image, perform an
Auto-Image (see
Auto Memory — Enables and disables Auto Memory. Auto Memories store the details
•
of an input signal in scaling bridge memory, so that the unit applies the appropriate
settings when it detects that signal again (see
either knob to set Auto Memory to
Adjust
• HDCP Authorized — Lets you disable HDCP communication by causing the
MediaPort input to report to a source device as a non-authorized HDCP sink (see
HDCP Authorized on the page 35). Rotate either
. The default is
Disabled
Selecting an input EDID
To select a resolution and rate for input emulation:
1. Select
HDMI Input EDID
2. Rotate the left
Adjust
refresh rate.
3. Press or wait until the LCD screen times out to the default cycle (approximately
Next
30 seconds). Your selection is saved and appears next time you access the
screen.
EDID
See the Input EDID Table
menu.
(fills the entire screen) or
Fill
.
Fill
) (see Picture Control Menu
Picture Controls
item on the
Picture Controls
, .
X Y
Performing Auto-Image
Auto Memories
(the default) and
On
.
Disabled
from the
Input Configuration
knob to select the resolution and the right knob to select the
on the next page for the EDIDs that can be selected from this
(displays with the
Follow
Picture Controls
on page 31).
menu.
menu to , and set the
0 0
Picture
on page 29).
on page 44). Rotate
.
Off
knob to select
Adjust Enabled
menu.
HDMI Input
MediaPort 200 • Operation
Size
or
34