Application 3 - Mediaport 200 With Hardware And Software Codecs - Extron electronics mediaport 200 User Manual

Application 3 — MediaPort 200 with Hardware and Software Codecs
This is an application for soft codec conferencing in a room that also has a hardware video
codec. Either codec can be used independently at any time This application uses the single
microphone input on the MediaPort 200 for both conferencing devices.
XPA 1002
MediaPort 200
POWER STANDBY
Camera
Figure 61.
Connecting the MediaPort 200 inputs and outputs
1.
Connect an HDMI source to the MediaPort input. In figure 61, an HDMI video camera is
used.
2. Connect the HDMI loop output on the MediaPort to the camera or content input on the
hardware video codec. Alternatively, if you are using a matrix switcher, you can connect
an output of the switcher to the hardware video codec.
3. Connect the MediaPort Line output to a sound reinforcement system.
4. Connect a microphone to the Mic/Line input.
5. Connect a USB cable between the rear panel USB type B connector and your PC or
Mac computer. Make sure that the drivers are configured properly.
6. Set the MediaPort 200 to enumerate as a speakerphone device without AEC (see
Configuring Windows for MediaPort 200
Audio
OVER 1 2
TEMP
LIMITER/PROTECT
SIGNAL
XPA 1002
100-240V - - A MAX
HDMI
REF AUX
LINE MIC/LINE LINE USB
L R L R
LOOP OUT
+48V
OUTPUT
INPUT
50/60 Hz
Application 3 — MediaPort with Hardware and Software Codecs
'
I1 I2 G O1 O2
I/O
LAN
RS-232 +12V
RESET
Tx Rx G
0.1A
MAX
REMOTE
Video/Audio
Table Microphone
Video Codec
on page 15).
MediaPort 200 • Audio Application Setup
PC
HDMI DA
Display
91