Front Panel Lockout (Executive Mode); Resetting - Extron electronics mediaport 200 User Manual

•
•
•

Front Panel Lockout (Executive Mode)

To prevent accidental changes to settings, you can lock the MediaPort 200 front panel
controls by placing the unit in lock (executive) mode. While the MediaPort is in lock mode,
Ethernet, RS-232, and USB communication remain available, as well as the ability to exit lock
mode. The front panel lock setting is retained after a power cycle.
•
•
Lock mode also can be enabled and disabled via SIS commands (see the
Lock (Executive Mode) commands

Resetting

Resetting the unit causes various settings to revert to factory defaults. Three methods of
resetting the MediaPort 200 are available:
•
•
IP Address: Set the MediaPort 200 IP address. An IP address is a 32-bit binary
number that is used to identify each device on an Ethernet network. This number
consists of four decimal numbers called "octets," each in the range of 0 through 255
and separated by dots. The default address is
Gateway Address: If required by your network, set the address of the gateway. The
default gateway address is
Subnet Mask: Set the subnet mask. This number, in the form of an IP address, is
used to compare and determine whether the local and remote devices are on the same
subnet or different subnets. The default is
To enable lock mode, press and hold the
Executive Mode Enabled
same message is displayed any time a front button is pressed or a knob is rotated.
To disable lock mode, press and hold the
appears in the LCD window (approximately 5 seconds).
Mode Disabled
Reset button — There are three reset modes (numbered 1, 4, and 5 for the sake
of comparison with Extron IP Link products) that are available by pressing the
button on the rear panel. This button is recessed, so you must use a pointed stylus,
ballpoint pen, or small screwdriver (such as the provided Extron Tweeker) to press it the
appropriate number of times. The
provides an explanation of each reset mode.
Front panel menus — To reset the MediaPort to its factory settings but retain the
current firmware version, press the front panel buttons as follows:
a.
Press repeatedly until the
Menu
the LCD screen.
b. Press the button until
Next
c. Rotate either knob to display
Adjust
d. Press . The LCD screen displays
Next
e. Press again to start the reset.
Next
While the reset is in process, the screen displays
•
Do not use any front panel buttons or knobs until the reset is done.
When the reset is complete,
•
30 seconds, followed by the default cycle.
192.168.254.254
.
0.0.0.0
255.255.0.0
and
Menu Next
appears on the LCD screen (approximately 5 seconds). This
and
Menu
on page 60).
Reset Modes Summary table
Advanced Configuration
is displayed.
Factory Reset
or
<Yes> <No>
Press Next for Factory Reset
Extron MediaPort 200
MediaPort 200 • Operation
.
.
buttons simultaneously until
buttons until
Next Executive
Front Panel
Reset
on the next page
menu is displayed on
.
.
Factory Reset Please Wait
is displayed for
.
42