Value Outside The Range Error Message - HID FARGO HDP5000 User Manual

Setting
Film Factory Take-up
Film Factory Supply
Transfer Delay
Durable Cooling Delay
Durable Film Print Cooling
Level
Durable Film Trans Cooling
Level
4.7.2

Value outside the range error message

If typing a value outside the range, an error message will display specific to the setting.
Note: The ## will correspond to the correct number per the setting.
L000950, Version: 4.0
ToolBox
Description
This setting corrects for motor speed variation of the film take-up motor.
The range is -20 to +20.
The larger the value the faster the motor goes.
Note: This is a factory setting, the user should never adjust this.
This setting corrects for motor speed variation of the film take-up motor.
The range is -20 to +20.
The larger the value the faster the motor goes.
Note: This is a factory setting, the user should never adjust this.
This option adds a delay (in millisecond) between when the card is queued
for transfer and the start of transfer.
This setting can be set between 0 and 1500, with each unit adding a
1 millisecond delay
This setting adjusts the delay (in seconds) before transferring the second
side of the card when Clear High Durable HDP Film is installed.
This setting can be set between 0 and 600, with each unit adding a
1 second delay.
This option adds an offset to the transfer roller temperature when Clear High
Durable HDP film is installed.
This option controls the fan speed and on-times of the transfer cooling fan
during transfer when Clear High Durable HDP Film is installed.
Page 4-16
February 2016