HID FARGO HDP5000 User Manual page 69

Page 5-7
LCD Error Message
Laminate 1 Jam
(PC Error Message No. 229)
Laminate 1 Low
(PC Error Message No. 239)
Laminate 1 Out
(PC Error Message No. 208)
Laminate 2 Bad
(PC Error Message No. 260, 262)
Laminate 2 Jam
(PC Error Message No. 230)
Laminate 2 Low
(PC Error Message No. 240)
Laminate 2 Out
(PC Error Message No. 209)
Lm1 Headlift Err
(PC Error Message No. 217)
Lm2 Headlift Err
(PC Error Message No. 218)
Mag Encoder Paused
(PC Error Message No. 143)
Mag Encoder Startup Error
(PC Error Message No. 63 and 141)
Mag Verify Error
(PC Error Message No. 30)
Multiple Feed
(PC Error Message No. 70)
No E-card Encoder
(PC Error Message No. 202)
No Film
(PC Error Message No. 28)
February 2016
Cause
A Jam occurred with the Laminator
material in Cartridge 1.
The material is getting low in
Lamination Cartridge 1.
The Laminate in Cartridge 1 has run
out.
The Lamination material in Cartridge
2 is not valid for this Laminator.
A Jam occurred with the Laminator
material in Cartridge 2.
The material is getting low in
Lamination Cartridge 2.
The Laminate in Cartridge 2 has run
out.
The Laminator failed to move or sense
the lower (Lam module 1) head.
The Laminator failed to move or sense
the upper (Lam Module 2) head.
The Magnetic Encoder is in a pause
state.
A problem was detected during
Printer start-up.
Print could not verify MAG write.
OR
The magnetic stripe was not encoded
properly.
Multiple cards were fed into the
Printer.
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
Film is not installed in the Printer.
OR
Film RFID tag is bad.
Troubleshooting
Solution
Open Lam cover and clear the
obstruction
Make sure more is on hand for when it
runs out.
Replace it with a new roll of material.
Install valid material.
Open Lam cover and clear the
obstruction.
Make sure more is on hand for when it
runs out.
Replace it with a new roll of material.
Check head connections and call for
service/repair.
Check head connections, call for
service/repair.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Check the Cards and click Cancel
Print.
Remove all cards and try again.
To cancel, click Cancel Print.
Install the Film and press Resume.
To cancel the print, press the Cancel
Print button or the Cancel button
located on the Printer.
L000950, Version: 4.0