HID FARGO HDP5000 User Manual page 78

Printer Error Message
Laminator Film Break/Jam
Laminator Film Sensor Error
Remove Laminator Film
Laminator Film Out
Laminator Film is not
Installed
Laminator Film Sensor Error
Wrong Laminator Film
Installed
L000950, Version: 4.0
Troubleshooting
Cause
A Film break/jam has been
detected inside the Laminator.
The Laminator cannot find the
next panel on the Film.
To continue, remove the
laminator's film.
The film installed in the printer is
empty.
No film is installed in the Printer.
The Printer cannot find the next
panel on the Print Film.
An incorrect Print Film has been
installed, or a driver setting is
incorrect.
Solution
The printer has determined that one or both
overlaminate films have either jammed or broken.
Open the Laminator Cover and remove the
Laminator Cartridge(s). If overlaminate is jammed,
remove jam and tighten the material.
Clear any cards in the printer by using the Forward
and/or Back buttons located on the Printer's LCD
display.
Tape the ends of the overlaminate together and
wind any excess onto the Take-up Spool of the
Overlaminate.
Re-install the Laminator Cartridge(s), close the
Laminator Cover and press the Resume button
located on the Printer's LCD display to continue
printing.
To cancel the print, press the Cancel Print button
from the Driver's display dialog and the Cancel
button located on the Printer's LCD display.
Check that the Film is installed properly and press
Resume.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Open the Laminator's Front Cover. Remove the film
and close the Laminator's Front Cover.
Install new Film and press the Resume button to
continue printing.
To cancel the print, press the Cancel Print button or
the Cancel button located on the Printer.
Install the Film and press Resume.
To cancel the print, press the Cancel Print button or
the Cancel button located on the Printer.
Check that the Print Film is installed properly and
press Resume.
To cancel the print, press the Cancel Print button or
the Cancel button located on the Printer.
Ensure that the appropriate Print Film is installed
and press the Resume button located on the Printer
to continue printing.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Page 5-16
February 2016