Settings Information - HID FARGO HDP5000 User Manual

Page 4-7
4.7.1

Settings Information

Setting
Head Resistance
Print Left of Form (LOF)
February 2016
Description
This is factory set. If the main board or the printhead is replaced then
adjust this number. Locate the Printhead Setting Number on the bottom of
the printhead. The number reads R=XXXX.
Print the alignment card self-test.
Adjust the Print LOF up or down until the border of the LOF zero line is
showing on the edge of the card.
Measure the density square. Adjust the image density to 65% ± 1%.
Note: The 500 Series Densitometer is to be used for this measurement.
LOF Zero Line
Density square set to 65% +/- 1%
ToolBox
L000950, Version: 4.0