HID FARGO HDP5000 User Manual page 77

Page 5-15
Printer Error Message
Headlift Error
Invalid Password
Laminator (General Error)
Laminator (Check Power)
Laminator (Heater Off)
Laminator (Heater Timed
Out)
No Laminator Film Installed
Wrong Laminator Film
Installed
Laminator Film Out
February 2016
Cause
The Headlift Sensor is not
detecting movement from the
Headlift Cam.
The Password entered is not a
valid password.
The Laminator has reported a
general fault.
The Laminator's power is OFF.
The Laminator's Heater is OFF.
The Laminator cannot reach the
desired operating temperature.
No laminator Film is installed in
the laminator unit.
An incorrect laminator film has
been installed, or a driver setting
is incorrect.
The Film installed in the
laminator is empty.
Troubleshooting
Solution
Reboot the Printer by cycling power.
To cancel, press the Cancel Print button.
Press OK to enter another password.
To cancel, press the Cancel Print button.
Press the Resume button located on the Printer to
continue.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Ensure that the laminator's power cord is properly
connected, cycle power and press the Resume
button to continue.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Press the Resume button to continue.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Reboot the Printer by cycling power. Check the
Laminator settings in the Printer Driver.
Click Default located on the Lamination tab of the
driver to set the Laminator settings to the factory
default.
Resend the print job.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Ensure that the appropriate Laminator Film is
installed.
To cancel the print, press the Cancel Print button or
the Cancel button located on the Printer.
Ensure that the appropriate Laminator Film is
installed and press the Resume button located on
the Printer to continue printing.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Install the Film and press Resume.
L000950, Version: 4.0