HID FARGO HDP5000 User Manual page 54

Setting
Image Darkness
Print Top of Form (TOF)
Edge of Transfer
Transfer Alignment Block
Image Once Adjusted
L000950, Version: 4.0
ToolBox
Description
Use this option to set the overall darkness of the printed image by
increasing or decreasing the amount of heat the printhead uses while
printing.
Use the up/down arrows to increase or decrease the amount of heat.
Important: If the value is set too high, the ribbon may jam or break
Print the alignment card self-test.
Adjust the Print TOF until the green border is eliminated and the entire
transfer alignment block is as shown in the bottom graphic.
Note: Due to variation in roller alignment, the green border may appear at a
slight angle on the top of the card.
(Green Border)
Page 4-8
February 2016