HID FARGO HDP5000 User Manual page 68

LCD Error Message
Job Data Error
(PC Error Message No. 106)
Lam 1 Tag Err
(PC Error Message No. 259)
Lam 2 Tag Err
(PC Error Message No. 260)
Lam Async Error
(PC Error Message No. 245)
Lam Card Jam
(PC Error Message No. 53, 212, 214,
and 215)
Lam Check Card
(PC Error Message No. 213)
Lam Com Error
(PC Error Message No. 246)
Lam Error
(PC Error Message No. 237, 238)
Lam Card Not Ejected
(PC Error Message No. 216)
Lam Handler Startup Error
(PC Error Message No. 66)
Lam Handler Startup Error
(PC Error Message No. 141)
Lam Internal Error
(PC Error Message No. 48)
Lam No Film
(PC Error Message No. 157)
Lam Timeout
(PC Error Message No. 247)
Lam1 Wrong Film
(PC Error Message No. 233)
Lam2 Wrong Film
(PC Error Message No. 234)
Laminate 1 Bad
(PC Error Message No. 259, 261)
L000950, Version: 4.0
Troubleshooting
Cause
The print data sent to the Printer is
corrupt or has been interrupted.
A RFID read or write error occurred
on Cartridge 1.
A RFID read or write error occurred
on Cartridge 2.
The Printer timed out waiting for
communication from the Laminator.
A jam occurred somewhere between
the Printer and the Laminator.
A jam occurred inside the Laminator.
There was a communication failure
between the Printer and Laminator.
A generic unknown error as occurred.
The card is not ejected from the
Laminator.
A problem was detected during
Printer start-up.
After powering up the Printer, the
Laminator was detected, but an error
occurred which would prevent its use.
A generic unknown error as occurred
in the Laminator.
There is no material loaded in the
Laminator.
The Printer timed out while
processing information related to the
Laminator.
Material in Cartridge 1 of the
Laminator does not match the
material type specified by the job.
Material in Cartridge 2 of the
Laminator does not match the
material type specified by the job.
The Lamination material in Cartridge 1
is not valid for this Laminator.
Solution
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Retry, and if it fails again the material
cannot be used.
Retry, and if it fails again the material
cannot be used.
Check Lam power/connections and
restart the Printer.
Open covers and clear the
obstruction/jam.
Open Lam cover and clear the
obstruction.
Check Lam power/connections and
restart the Printer.
Reset the Printer and try again. If this
problem persists, call for technical
assistance.
The Lamination material is stuck to the
card.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Check Laminator power and
connections and restart the Printer.
Check Laminator power and
connections and restart the Printer.
Load Laminator material.
Check Lam power/connections and
restart the Printer.
Make sure Driver material matches
what is actually in the Laminator.
Make sure Driver material matches
what is actually in the Laminator.
Install valid material.
February 2016
Page 5-6