HID FARGO HDP5000 User Manual page 39

Page 3-21
Group or Field
Lamination Speed
Lamination Side
Lamination Type
Automatically
Detect Installed
Laminate for Every
Print Job
Default
February 2016
Description
Transfer Dwell Time: Adjust this control for the through-put speed of a card in seconds
per inch. Range is 5.5 to 0.8 seconds, with a default of 2 seconds.
To specify the side(s) of the card to laminate select:
• No Lamination (if the laminator is not to be used)
• Laminate Front Side
• Laminate Back Side
• Laminate Both Sides
• Laminate Opposite Sides
Cartridge 1 & 2: Select one of the lamination type options, according to which type of
lamination media is currently installed. Two types of overlaminates, film and PolyGuard,
are supported by the driver. Custom versions of each type are also available.
Selections are:
• Film Lamination: Select if the thermal transfer film overlaminate type is installed in
the lamination module.
• 0.6 PolyGuard Lamination: 0.6 is the patch thickness.
• 1.0 PolyGuard Lamination: 1.0 is the patch thickness.
Note: The two PolyGuard Lamination patches require different heat settings and
lamination speeds. Select the appropriate option according to the thickness of the
PolyGuard material in use.
• Registered Film Lamination
• Holographic Film Lamination
Transfer Temperature: If the checkbox to auto detect is selected, the temperature will
be automatically set. The slider can change the temperature if a different one is
required.
Select this option for auto detection of the laminate installed. Default is enabled.
In the firmware, the values are updated on initialization and cover closing. If values in
the PRN file do not match the selected ones, the LCD displays a laminate error.
Returns the transfer dwell time and temperature to the default settings for the
lamination type in use.
Printer Driver Operations
L000950, Version: 4.0