HID FARGO HDP5000 User Manual page 70

LCD Error Message
No Flip Module
(PC Error Message No. 201)
No Flip Module
(PC Error Message No. 45, 201)
No iCLASS Encoder
(PC Error Message No. 177)
No Mag Module
(PC Error Message No. 31)
No MIFARE Encoder
(PC Error Message No. 203)
No Prox Encoder
(PC Error Message No. 32)
No Ribbon
(PC Error Message No. 25)
No Smart Encoder
(PC Error Message No. 33)
Printing Error
(PC Error Message No. 107)
Reboot Required
(PC Error Message No. 9, 65, 67, 163)
Reinsert Ribbon
(PC Error Message No. 141)
Remove Card
(PC Error Message No. 68)
L000950, Version: 4.0
Troubleshooting
Cause
Two-sided job sent to a one-sided
Printer.
The desired lamination requires a
Flipper Module.
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
MAG encoding job sent to Printer
without a MAG Encoder.
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
No Ribbon is installed in the Printer.
OR
The Ribbon RFID tag is bad.
You are trying to send encoding data,
but the Printer is not configured with
this Encoder type.
An error was detected during
printing.
Unspecified system error detected by
the Printer Firmware.
The Ribbon must be reinserted for
proper functioning of the Printer.
A card is jammed in the Print Station
or card flipping area of the Printer.
Solution
Verify the Printer has flipper
capabilities through the LCD Menu.
If Flipper capabilities are present,
ensure that the Print Both Sides option
in the Driver is set correctly.
Press Resume on the Printer's Front
Cover to continue printing.
To cancel the print, press Cancel Print
from the Driver's display dialog.
Change the Cartridge location of the
Lamination material (if it is dual sided),
or buy a Flipper Module.
To cancel, click Cancel Print.
To cancel, click Cancel Print.
To cancel, click Cancel Print.
To cancel, click Cancel Print.
Install the correct Ribbon and press
Resume located o the Printer's LCD
display.
To cancel the print, press the Cancel
Print button from the Driver's display
dialog and the Cancel button located
on the Printer's LCD display.
To cancel, click Cancel Print.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reinsert the Ribbon or press Resume.
Clear the jam and press Cancel.
February 2016
Page 5-8