HID FARGO HDP5000 User Manual page 57

Page 4-11
Setting
Transfer Temp Offset
Encoder Flip Angle
Print Flip Angle
Ribbon Print Take-up Tension
February 2016
Description
Both the printer itself and the printer's software driver control the built-in
transfer roller.
To change the temperature of the transfer roller, adjust its temperature
through the image transfer tab within the printer driver setup window.
Once adjusted, the new temperature settings will be sent down with the next
print job along with the rest of the printer driver information.
Before printing begins, the transfer roller will automatically adjust itself to
the new temperature setting. This new temperature setting will remain
programmed within the printer until it is once again changed within the
printer driver or until the printer is turned off.
Whenever the printer is turned OFF, the transfer roller will automatically
reset itself and return to its default temperature the next time the printer is
turned ON.
Disconnect the printer's power supply.
Technician Note: Cycling the printer's power supply serves to reset the
transfer roller to its default temperature. The temperature setting within the
printer driver, however, will stay the same until it is changed.
Danger: The printer's transfer roller can reach temperatures exceeding 350°
F (175° C). Use extreme caution when operating the transfer roller. Never
touch the transfer roller unless the printer power has been turned off for at
least 20 minutes.
Danger: Le rouleau de transfert de l'imprimante peut atteindre des
températures supérieures à 350 ° F (175 ° C). Soyez extrêmement prudent
lorsque vous utilisez le rouleau de transfert. Ne touchez jamais le rouleau de
transfert à moins que l'alimentation de l'imprimante a été éteint pendant au
moins 20 minutes.
Use the Encoder Flip Angle option to fine tune the position of the flipper.
ONLY used if encoder is present
Use the Print Flip Angle option to set the position of the flipper so it is level
with the card path after a flip operation.
This procedure controls the tension of the color ribbon during printing.
Adjust the ribbon tension if ribbon wrinkle is appearing on the card.
Note: Adjustments moderately change the image length.
ToolBox
L000950, Version: 4.0