HID FARGO HDP5000 User Manual page 60

Setting
Cleaning Rate
Film Print Cooling Level
Film Transfer Cooling Level
Environmentally Adaptive
Transfer (EAT) Disable
Enable Ribbon Wrinkle
Compensation
Standby Time
BEEP Disable
I-Panel Heat Offset
Holo Transfer Offset
Standby Temp
Mag Hi-Co Voltage Offset
Mag Lo-Co Voltage Offset
Mag Flipper Angle Offset
Fluorescent (F) Panel Heat
Offset
Lamination End of Form
Lamination Bottom Takeup
Lamination Top Takeup
L000950, Version: 4.0
ToolBox
Description
This adjustment changes the cleaning rate from 3000 to whatever the new
setting is.
This controls the speed of the transfer roller cooling fan during the printing
process.
This setting should normally be off, but can be turned on to help with
splotchy color areas on the image.
Note: Too high of a fan speed can cause smudge.
This controls the default speed of the cooling fan for the transfer process.
Adjustments can be made to both fan speeds and on-times during
transferring.
Note: This setting affects both flash and smudge.
Environmentally Adaptive Transfer automatically adjusts the transfer
temperature based on the ambient air conditions within the printer.
This is an ON (1) or OFF (0) switch. Default is ON.
Note: Settings can increase or decrease the transfer roller temp by as much
as 68° F (20° C) in extreme conditions.
This is an ON (1) or OFF (0) switch. Default is ON.
When this is enabled, it will turn on extra pixels on the printhead to help with
ribbon wrinkle during the print process.
This option changes the time until the printer enters standby mode.
This setting will disable the beep the printer generates after an EE setting
gets updated.
This option adjusts the heat used during the removal of unwanted film.
Note: Use minimal adjustments, or print ribbon and film breaks may occur.
This option changes the hologram overlaminate offset placement
parameters.
This option changes the temperature used when the printer is in standby
mode.
This option changes the voltage going to the magnetic head.
Note: This is factory set and should only be changed by a technician.
This option changes the voltage going to the magnetic head.
Note: This is factory set and should only be changed by a technician.
This option changes the angle of the flipper table. Increasing the flipper
angle will rotate the flipper table clockwise.
Note: This is factory set and should only be changed by a technician.
This setting adjusts how dark or light the fluorescent panel is printed.
The range is +/-
This option changes head lift at end of card.
This option changes tension of laminate roller 1.
This option changes tension of laminate roller 2.
20.
Page 4-14
February 2016