HID FARGO HDP5000 User Manual page 66

LCD Error Message
E-Card Startup Error
(PC Error Message No. 141)
EEPROM Corrupt
(PC Error Message No. 38, 39, 40,
144)
Ejecting Card
(PC Error Message No. 72)
Empty Reject Bin
(PC Error Message No. 265)
Failed To Initialize
(PC Error Message No. 141)
Film Align Error
(PC Error Message No. 26, 176)
Film Break/Jam
(PC Error Message No. 158)
Film Low
(PC Error Message No. 156)
Film Out
(PC Error Message No. 156, 157)
Film: Wrong Material
(PC Error Message No. 173)
L000950, Version: 4.0
Troubleshooting
Cause
A problem was detected during
Printer start-up.
EEPROM restored with factory default
values.
The card has been ejected already.
The reject bin is full.
A problem was detected during
Printer start-up.
The film is not able to move correctly.
Check for jams/breaks.
The film is not able to move correctly.
Check for jams/breaks.
The HDP film will soon run out.
The HDP film has run out.
The HDP Film is not installed properly
or has been damaged.
Solution
Reset the Printer and try again. If this
problem persists, call for technical
assistance.
If changes were made, then go into the
setting values and reset these
numbers.
Click OK to clear the message. The
User might want to know that a card
has been sent to the reject bin, or out
of the printer, and is either incomplete
or posses a security risk if not
disposed of properly.
Remove the large number of rejected
cards from the reject bin.
Click OK to clear the notification
message. (Note: In some cases,
rejected cards are incomplete or pose
a security risk, and should be disposed
of properly.)
Reset the Printer and try again. If this
problem persists, call for technical
assistance.
Check for obstruction. If the problem
persists, call for technical assistance.
Check for obstruction. If the problem
persists, call for technical assistance.
If printing a large number of cards,
replace the Film now or monitor the
Printer until the Film is gone and install
a new Film.
Install a new roll of film and press
Resume to continue or Cancel to reset.
Verify the correct film is installed in
the film Cartridge.
February 2016
Page 5-4