HID FARGO HDP5000 User Manual page 33

Page 3-15
Field
Transfer
Parameters
Default
February 2016
Description
The following graphic represents how the printed image will move in relation to the
fixed card position as positive and negative image values are entered.
The maximum value for the vertical and horizontal adjustments is ±100 Pixels
(10 Pixels = 0.03 [0.8mm]).
Card Output
Side of Printer
(Card Left)
Direction card travels through printer
These settings control the speed and temperature at which printed images are
transferred from the film to the card. These settings may vary depending on the card
type.
The printer driver automatically optimizes these settings according to the card type and
film type previously selected.
Changes made to the dwell time and temperature settings are saved for the selected
card type option upon exiting the printer driver setup.
Transfer Dwell Time: Transfer Dwell Time sets dwell time for InTM transfer in seconds
per inch.
• Lower limit = 1.0 seconds per inch
• Upper limit = 3.0 seconds per inch
Transfer Dwell Time defaults:
• UltraCard III - Premium: Default = 2.0 seconds per inch
• UltraCard - PVC: Default = 2.0 seconds per inch
• Custom: Default = 2.0 seconds per inch
Transfer Temperature: Transfer Temperature Sets temperature for InTM transfer in
Celsius.
°
• Lower limit = 150 C
°
• Upper limit = 190 C
• UltraCard - Premium: Default = 185
• UltraCard- PVC: Default = 175
• Custom: Default = 175°C
This option will return the settings to the factory default settings for the selected card
type.
Printer Driver Operations
Rear of Printer
(Card Back)
Card Input
Side of Printer
(Card Right)
Front of Printer
(Card Front)
°
C
°
C
L000950, Version: 4.0