HID FARGO HDP5000 User Manual page 71

Page 5-9
LCD Error Message
Remove Ribbon
(PC Error Message No. 139)
Remove Lam Material
(PC Error Message No. 210)
Remove Lam1 Mtl
(PC Error Message No. 204)
Remove Lam2 Mtl
(PC Error Message No. 205)
Ribbon Break/Jam
(PC Error Message No. 99, 108, 109)
Ribbon Low
(PC Error Message No. 92)
Ribbon Miscue
(PC Error Message No. 97)
Ribbon Out
(PC Error Message No. 91, 100, 101)
Ribbon Tension
(PC Error Message No. 98)
Ribbon: Wrong Material
(PC Error Message No. 93, 122, 172)
System Fault
(PC Error Message No. 164)
Unable to Feed
(PC Error Message No. 14, 81)
February 2016
Cause
The print Ribbon is not installed
properly or has been damaged.
Single Sided Lam job specified but
the material is loaded in both
Modules.
Single sided lamination on the back
side is specified but material is loaded
in the Lam 1 Module.
Single sided lamination on the front
side is specified but material is loaded
in the Lam 2 Module.
The Ribbon is not able to find the next
panel correctly. Check for
jams/breaks.
The print Ribbon will soon run out.
The Ribbon is not able to find the next
panel correctly. Check for
jams/breaks.
The print Ribbon has run out.
The Ribbon tensions may be out of
range.
The print Ribbon is not installed
properly or has been damaged.
Unspecified system error is detected
by the Printer Firmware.
The Printer is unable to feed a card
from the Card Cartridge
Troubleshooting
Solution
Verify the correct Ribbon is installed in
the Ribbon Cartridge.
Remove it and replace it with the
correct Ribbon.
Remove either Lamination Cartridge.
Remove Cartridge 1.
Remove Cartridge 2.
If jammed, clear the jam. If broken,
repair by taping the Ribbon back on to
the take-up core.
Press Resume to continue or Cancel to
abort.
If printing a large number of cards,
replace the Ribbon now or monitor the
Printer until the Ribbon is gone and
install a new Ribbon.
If jammed, clear the jam. If broken
repair by taping the Ribbon back on to
the take-up core.
Press Resume to continue or Cancel to
abort.
Install a new Ribbon and press Resume
to continue.
Check and adjust the setting through
the TOOLBOX under the Advanced
Settings tab.
If this problem persists, call for
technical assistance. Press Resume to
continue or Cancel to abort.
Verify the correct Ribbon is installed in
the Ribbon Cartridge.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Verify there are cards in the Card
Cartridge.
Verify cards are not stuck together or
jammed, and they are the correct
thickness.
L000950, Version: 4.0