Check Paper Size Setting On Control Panel For Drawer N - Toshiba e-Studio 232 Operator's Manual

Multifunctional digital systems basic functions
Hide thumbs Also See for e-Studio 232:
Table of Contents

Advertisement

7. "Check paper size setting on control panel for drawer N"

This message appears when the size of the paper actually placed in the drawer or on the bypass tray dif-
fers from the one registered in the equipment for the corresponding drawer or the bypass tray. There are 5
messages of this type as shown below.
"Check paper size setting on control panel for drawer 1"
"Check paper size setting on control panel for drawer 2"
"Check paper size setting on control panel for drawer 3"
(Only when the Paper Feed Pedestal (optional) is installed)
"Check paper size setting on control panel for drawer 4"
(Only when the Paper Feed Pedestal and the Additional Drawer Module (optional) are installed)
"Check paper size setting on control panel for Bypass"
In case that a paper misfeed occurs and one of the above messages consequently appears, another
paper misfeed will occur if you just remove the jammed paper. Instead, be sure to follow the procedure
below.
Make a note of the position of the jammed paper and the number of the drawer displayed in the mes-
sage in advance because guidance for removing the jammed paper is not displayed while you are
working on the procedure.
This countermeasure differs depending on when the paper misfeeding has occurred – during copying or
during printing from the Fax or the Printer.
10
During copying (using a drawer)
1
Turn the power of the equipment OFF.
• You cannot shut down the equipment.
2
Remove the jammed paper.
P.274 "4.Jam Symbols"
308
10.WHEN THIS MESSAGE APPEARS

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-studio 282

Table of Contents