Prom Writing Tools; Hardware; Software; B.2.1 Hardware - NEC PD78052 User Manual

B.2 PROM Writing Tools

B.2.1 Hardware

PG-1500
PROM Programmer
PA-78P054GC
PA-78P054GK
PA-78P054KK-T
PROM Programmer Adapter

B.2.2 Software

PG-1500 Controller
Remark xxxx in the part number differs depending on the host machine and OS used.
Sxxxx PG1500
xxxx
5A13
5B13
Note
584
APPENDIX B DEVELOPMENT TOOLS
A PROM programmer that, by connecting the attached board and separately
available PROM programmer adapter, is capable of programming single-
chip microcomputers incorporating a PROM on stand-alone basis or through
operation from the host machine.
Also capable of programming typical 256-Kbit to 4-Mbit PROM.
A PROM programmer adapter for the PD78P054, 78P058, and 78P058Y.
Used connected to the PG-1500.
PA-78P054GC : 80-pin plastic QFP (GC-3B9, GC-8BT type)
PA-78P054GK : 80-pin plastic QFP (GK-BE9 type)
PA-78P054KK-T : 80-pin ceramic WQFN (KK-T type)
Connects PG-1500 and the host machine with serial and parallel interface,
and controls the PG-1500 on the host machine.
The PG-1500 controller is a DOS-based application. Use it with the DOS
prompt on Windows.
Part number: SxxxxPG1500
Host Machine
PC-9800 series
IBM PC/AT and
compatibles
MS-DOS ver. 5.0 or later has a task swap function, but it cannot be used with the above

software.

OS
MS-DOS
Note
(ver. 3.30 to ver. 6.2 )
Refer to B.4
Supply Media
3.5-inch 2HD FD
3.5-inch 2HC FD