NEC PD78052 User Manual page 389

CHAPTER 17 SERIAL INTERFACE CHANNEL 0 ( PD78054Y Subseries)
• Example of program releasing serial transfer status
SET1 P2.5; <1>
SET1 PM2.5; <2>
SET1 PM2.7; <3>
CLR1 CSIE0; <4>
SET1 CSIE0; <5>
SET1 RELT; <6>
CLR1 PM2.7; <7>
CLR1 P2.5; <8>
CLR1 PM2.5; <9>
<1> This instruction prevents the SDA0 pin from outputting a low level when the I
by instruction <5>. The output of the SDA0 pin goes into a high-impedance state.
<2> This instruction sets the P25 (/SDA0) pin in the input mode to protect the SDA0 line from adverse
influence when the port mode is set by instruction <4>. The P25 pin is set in the input mode when
instruction <2> is executed.
<3> This instruction sets the P27 (/SCL) pin in the input mode to protect the SCL line from adverse influence
when the port mode is set by instruction <4>. The P27 pin is set in the input mode when instruction
<3> is executed.
<4> This instruction changes the mode from I
<5> This instruction restores the I
<6> This instruction prevents the SDA0 pin from outputting a low level when instruction <8> is executed.
<7> This instruction sets the P27 pin in the output mode because the P27 pin must be in the output mode
2
in the I C bus mode.
<8> This instruction clears the output latch of the P25 pin to 0 because the output latch of the P25 pin
must be set to 0 in the I
<9> This instruction sets the P25 pin in the output mode because the P25 pin must be in the output mode
2
in the I C bus mode.
Remark RELT: Bit 0 of serial bus interface control register (SBIC)
2
C bus mode to port mode.
2
C bus mode from the port mode.
2
C bus mode.
2
C bus mode is restored
389