Cautions Related To D/A Converter; Use Example Of Buffer Amplifier - NEC PD78052 User Manual

Pd78054 series; pd78054y series 8-bit single-chip microcontrollers
Table of Contents

Advertisement

15.5 Cautions Related to D/A Converter

(1) Output impedance of D/A converter
Because the output impedance of the D/A converter is high, use of current flowing from the ANOn pins (n =
0,1) is prohibited. If the input impedance of the load for the converter is low, insert a buffer amplifier between
the load and the ANOn pins. In addition, wiring from the ANOn pins to the buffer amplifier or the load should
be as short as possible (because of high output impedance). If the wiring may be long, design the ground
pattern so as to be close to those lines or use some other expedient to achieve shorter wiring.
PD78054, 78054Y
PD78054, 78054Y
(2) Output voltage of D/A converter
Because the output voltage of the converter changes in steps, use the D/A converter output signals in general
by connecting a low-pass filter.
(3) AV
pin
REF1
When only either one of the D/A converter channels is used with AV
as analog outputs must be set as follows:
Set PM13x bit of the port mode register 13 (PM13) to 1 (input mode) and connect the pin to V
Set PM13x bit of the port mode register 13 (PM13) to 0 (output mode) and the output latch to 0, to output
low level from the pin.
286
CHAPTER 15 D/A CONVERTER
Figure 15-3. Use Example of Buffer Amplifier
(a) Inverting amplifier
R
1
ANOn
• The input impedance of the buffer amplifier is R
(b) Voltage-follower
R
ANOn
R
1
• The input impedance of the buffer amplifier is R
• If R
is not connected, the output becomes
1
undefined when RESET is low.
C
R
2
C
< V
, the other pins that are not used
REF1
DD
.
1
.
1
.
SS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents