wsm M108S Workshop Manual page 145

M108S, WSM
Air Condenser and Compressor
Without discharging the refrigerant from system
1. Remove the air condenser slide stopper (1) and slide out the air
condenser (2).
2. Loosen the lock nut (6) and adjusting screw (5) then remove the
air compressor belt (8).
3. Disconnect the wire 1P connector (3).
4. Disconnect the wire harness from glow relay (9).
5. Remove the starter relay (10), CRS power relay (11), fuse box
(12) and fuse box (13).
6. Remove the ground cable (14).
7. Disconnect the wire harness (16) and connector (17) from
alternator.
8. Disconnect the connectors (19), (20).
9. Remove the hose clamps (7), (18).
10.Remove the compressor bracket mounting screws.
11.Remove the compressor (4) and condenser (2) with hoses.
(When reassembling)
• Take care not to damage the air condenser fin.
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension. (Refer to "[5] CHECK POINTS OF
EVERY 200 HOURS" at "G. GENERAL" section.)
With discharge the refrigerant from system
1. Refer to "[2] DISCHARGING EVACUATING AND CHARGING"
at "10. CABIN" section.
(1) Stopper Screw
(2) Condenser
(3) 1P Connector
(4) Compressor
(5) Screw
(6) Lock Nut
(7) Clamp
(8) Air Compressor Belt
(9) Glow Relay
(10) Starter Relay
1-S22
ENGINE
(11) CRS Power Relay
(12) Fuse Box
(13) Fuse Box
(14) Ground Cable
(15) EGR Connector
(16) Wire Harness
(17) Connector
(18) Clamp
(19) Connector
(20) Connector
W1012592
KiSC issued 05, 2012 A