wsm M108S Workshop Manual page 282

M108S, WSM
Spiral Bevel Pinion Shaft
1. Remove the stake of the staking nut (1).
2. Set the pinion locking tool (2) (Code No. 07916-52311).
3. Remove the staking nut (1).
4. Tap out the bevel pinion shaft (3) to the rear.
(When reassembling)
• Replace the staking nut with new one, and be sure to adjust the
turning torque of spiral bevel pinion shaft only. (Refer to "6.
SERVICING" in this section.)
• There staking groove (4) and lubrication groove (5) on the pinion
shaft (3), be sure to stake the nut on right side groove.
(Reference)
1.2 mm (0.047 in.) collar (6) is built in the standard.
Spiral bevel pinion shaft
Tightening torque
staking nut
(1) Staking Nut
(2) Pinion Locking Tool
(3) Bevel Pinion Shaft
3-S36
TRANSMISSION
275 to 343 N·m
28 to 35 kgf·m
203 to 253 lbf·ft
(4) Staking Groove
(5) Lubrication Groove
(6) Collar
W1039618
KiSC issued 05, 2012 A