Wiper Motor - wsm M108S Workshop Manual

M108S, WSM

(7) Wiper Motor

Before Replacing Windshields (3)
1. Check that the glasses are not damaged and cracked.
2. Turn over the glass and clean this surface of the glass by Sika-
cleaner No. 1.
3. The cleaning area of the rear surface is indicated "A" in the
figure left.
NOTE
• If not cleaning the glass, it may result in adhesive failure.
(1) Upper Windshield
(2) Lower Windshield (Left)
(3) Lower Windshield (Right)
Front Wiper Motor
1. Remove the steering wheel and steering post under covers.
2. Remove the meter panel.
3. Remove the panel under cover.
4. Disconnect the front wiper motor 4P connector (2).
5. Remove the wiper arm mounting nut (4) and wiper arm (5).
6. Remove the wiper link cap (3).
7. Disconnect the earth lead setting screw.
8. Remove the front wiper motor bracket (7) mounting screw (8),
then take out the front wiper motor (1).
(When reassembling)
Tightening torque Wiper arm mounting nut
(1) Front Wiper Motor
(2) Front Wiper Motor Connector 4P
(3) Wiper Link Cap
(4) Nut
(5) Wiper Arm
10-S46
A : 25 mm (1.0 in.)
W1035931
6.4 to 9.3 N·m
0.65 to 0.95 kgf·m
4.7 to 6.8 lbf·ft
(6) Wiper Blade
(7) Wiper Motor Mounting Bracket
(8) Wiper Motor Bracket Mounting
Screw
(9) Ground Wire Mounting Screw
W1031321
KiSC issued 05, 2012 A
CABIN